Joining lines

Join makes two lines into one, with two clicks. Lines that cross or would meet if extended are trimmed or extended to their corner and become one open polyline through it, collinear lines (with a gap or without) become one straight line, and lines that meet end to end become one polyline. The result keeps the first line's layer and style. It works in plan and in a section, an elevation or a callout window.

Lines drawn with the Line tool join like any other line. On a polyline with more than two points, click the segment at the end you want to join: only that end moves, and a click on a middle segment says the lines do not meet and changes nothing.

Parallel lines that sit apart never meet, so Join leaves them as they are and says they are parallel. The first line stays highlighted until you click the second, and one undo takes the whole join back.

Joining polylines that came in from a DWG or DXF with widths gives one polyline in which each part keeps its own width, a taper included. A plain line in the join stays at no width.

In a wall's Edit Profile elevation, Join uses the sketch's Join at corner gesture: pick two edges to bring them to their corner. Choosing it with an opening selected clears that selection and arms the sketch gesture.

This planar tool refuses free Pencil linework that carries vertex heights, with a message explaining why. Move and Rotate keep those heights.

  1. Click Join on the left rail.
  2. Click the first line, then click the second.

The result stays in the view the lines were drawn in. A locked line, or one on a locked layer, is left alone and a message says so.