Placing lifts

A lift is a shaft you place with a click.

In Access, enable a level before making it Service only. A disabled level cannot be requested under Destination. Unavailable controls keep their text readable, show a not-allowed cursor and explain the reason when you point at them.

Deleting a level removes its stop, if the lift served it, and keeps the shaft ends at their existing heights. A shaft end that followed the deleted level becomes fixed, while surviving service bindings keep following their levels. Set From or To to a new level to reconnect the live service range. One Undo restores the level, its stop and the original bindings.

  1. Click Lift on the Build toolbar.
  2. Click where the shaft goes.

Parameters carries the last lift type used on to the next one, with Reset to default to clear it. Escape cancels.