Massing arcs

Arc draws one curved line.

Massing Arc draws a model curve in plan, section, elevation and callouts over a plan or a section, on the drawing plane. Draft Arc remains view-only ink.

In a section, elevation or callout, use Arc in the Draft tools to draw an arc in that view.

While bowing the arc, aim near a semicircle to catch Half Circle. If the start lies on a straight edge, aim near the tangent bow to catch Tangent to Edge. The arc turns magenta while caught. The perpendicular guide from the chord midpoint helps you aim the bow. These work in plan and 3D; a caught model point takes priority, and a held lock keeps its direction. Once both ends are placed, the bow starts free; use an arrow key to hold its direction.

  1. Choose Arc in Massing.
  2. Click the start, then click the end.
  3. Move to bow the line, and click to commit.

After clicking the start and end, type a Bulge, or press Tab and type a Radius, then press Enter to commit. This works in plan, on a section or elevation cut plane, in a callout window over a section, and in 3D. You can include units, such as 250cm or 2500mm. A radius must be positive and at least half the distance between the ends; an invalid radius shows a reason and keeps the draft ready to correct. Choose Radius with Tab if needed, type the corrected radius, then press Enter.

A line crossing an arc splits it at the crossing. Each resulting curve selects, moves, copies and deletes on its own. Use Weld to join connected pieces back into a curve. To break it into straight segments on purpose, select it, right-click and choose Explode Curve. The curved side of a Circle or Pie mass explodes the same way: select the side, choose Explode Curve, and each segment of it then selects on its own; one undo makes it a single curve again.