Terrain from a survey
A survey with spot heights or contours can build the terrain directly.
- On the Site row's Survey tab, click Import Topographic Survey…. It opens the ordinary CAD import; see Importing a DWG or DXF.
- When the import finds at least 12 elevation points or contour points, a toast says so and offers Build terrain. Click it.
- In Build terrain from survey?, choose how to Skin the area: Survey extent, Terrain Perimeter or Draw a boundary….
- Click Build terrain.
If anything looks like an unusual reading, a Temper to the surrounding ground checkbox appears. When more than one survey drawing is present, Drawings lists each with its point count. Afterwards the Survey tab shows the source, boundary and Points in drawing, with a Rebuild terrain button.
Editing ground built from a survey
The ground passes through every surveyed point exactly, between the grid points as well as on them. Raise, Lower and Smooth follow the survey: a bump you sculpt rides the surveyed ground. A Flatten stroke, Level lot, a pad or a platform holds its level everywhere inside it, so a building on a pad sits flat however finely you sample it.
The drawing shows that same ground. The 3D surface passes through every surveyed point; the plan's contours are traced from the surveyed ground itself, so a spot level and the contour at its height agree; a section's ground line bends wherever the survey changes slope along the cut; and roads and paths draped over the site follow it as well. On a large survey the exact 3D surface takes a moment to prepare when the drawing first opens, and until it's ready you see a close approximation of it. After that, the 3D surface updates as you edit the ground, without falling back to the approximation.
A drawing saved before surveyed ground worked this way keeps its shape when it opens. Every grid point stays at its height, and between them the ground now follows the survey. Its pads and platforms still hold their level. An old Flatten stroke over a survey left no record of itself, so it becomes relative: it keeps its level at each grid point but follows the survey between them, like a sculpt. Flatten that area again to hold it level everywhere.
If a site's saved ground can't be read, Linea tells you and leaves it exactly as saved. Ground editing stays switched off for that site (sculpting, pads, platforms and rebuilds), so nothing can write over the original data by accident.
The Site row then shows The ground data in this drawing could not be read and has been left untouched, at the top of the Sculpt and Settings tabs, with the ways out. Rebuild from survey appears when the drawing still holds survey spot heights or contours; it opens the usual Build terrain from survey? dialog, which says the unreadable data will be replaced. Discard ground asks you to confirm, then replaces the ground with flat ground at the site datum. Plots and platforms stay as they are, but their cut and fill is not re-applied to the flat ground. Either one is a single undo step, and Undo puts back the original data exactly as it was, until you close or reload the drawing. Until you use one of them, the ground stays as saved.