Offsetting faces and lines

Offset on the Massing toolbar makes a ring inside or round a face, or a parallel copy of a line.

For a loose model line or polyline in 3D, click the line caught by the cursor. Point to its side to see the parallel copy, then click or type the distance and press Enter. The source stays in place and the new line is one Undo step.

Before choosing the face, Face and Edge track the surface under the pointer in 3D and in each drawn view. The cue clears over empty space or when you leave the canvas. In Split, it follows the pane under the pointer.

To offset lines in a section, elevation or callout, use Offset in the Draft tools. To offset a wall in a plan, use Offset in the Modify tools; see Offsetting linework.

Massing Offset picks a massed face directly in a plan, section, elevation or either kind of callout. Click the face, then click to set the inset or type the distance and press Enter. The ring shows at once in that view and in 3D, and in any other drawing that sees the face. Draft Offset remains available for view-only lines.

  1. Switch to Massing and click Offset, or press F.
  2. Click a face and point inward or outward, or click a line to offset a parallel copy.
  3. Click again to confirm the thickness, or type a number and press Enter.

The face stays whole, whichever way you go. Inward leaves the inner face and a ring around it; outward leaves the face with a ring round it. Each Offset is one Undo, and a distance too large for the shape is refused with a message and changes nothing.

Both pieces carry on as faces. Push/Pull the ring up and you have a wall, and the inner face pushes or offsets on its own. Delete the ring on its own and its lines stay, leaving the inner face whole; delete the inner face the same way and the ring keeps the edge of its hole, with the inner outline standing as lines, and a curved side standing as one curve, on the outer edge as on the inner. Select the edge between them and press Delete, or rub it out with the Eraser, and they join into one face. Offset outward from the top of a block and the ring stays its own object beside the block; deleting the edge they share takes the ring and leaves the block closed.

Enter a group or component and Offset picks the faces of the masses inside it, in plan, section, elevation and callout alike. In a component the face you pick is on the copy you entered, and the change is made to the component itself, so every copy follows. A closed group or component is one object to it, and a click on one picks nothing.

Escape cancels.

With Offset armed, Delete or Backspace removes the selection. During an offset, the first press cancels its current leg like Esc and the next press deletes the selection. Offset stays armed. Backspace in a number field edits the number.